<div>This was sent to me via e-mail
and I am listing it for Bill.
LennyWe are back on the high seas,
in Golfito, Costa Rica, enjoying
the cruising
life. Internet and email access is
poor here. I could use some
help in finding the
email address of a member of
the Morgan group. His name is
Robert A.
Gustafson. He sent me some information
about tabbing breaks in the
head and cabinet
areas. I see some tears, but do
not know what this means or
how serious it
is. They seem to be superficial
or top layer tears. But I am getting some
squeaking of the cabin sole in
areas outside the head
and up near the sinks. I
wonder if I am getting some
separation in floor
support that need to be
addressed, or whether these
types of squeaks are just
something that can develop in
time. Robert had told me earlier
about adding glass tabbing to
the bulkhead areas
and the hull and the mast well
box. Additionally, glassing was
done at the
galley bulkhead, and a small
bulkhead was glassed into the
keel bilge
approximately adjacent to the
wet locker and chart table. The areas he mentions are the
areas I am getting the floor
squeaking. I am
not in a place where this type
of work can be done, nor are
materials
available. I just need to know
how critical this is, thus how
soon I must
address it. Thanks for any help you can
provide. Hope all is well with
your boat and
cruising activities. Best wishes
for the holiday season. Bill Gloege
Gaia
Banana Bay marina
Golfito, Costa Rica
</div>
and I am listing it for Bill.
LennyWe are back on the high seas,
in Golfito, Costa Rica, enjoying
the cruising
life. Internet and email access is
poor here. I could use some
help in finding the
email address of a member of
the Morgan group. His name is
Robert A.
Gustafson. He sent me some information
about tabbing breaks in the
head and cabinet
areas. I see some tears, but do
not know what this means or
how serious it
is. They seem to be superficial
or top layer tears. But I am getting some
squeaking of the cabin sole in
areas outside the head
and up near the sinks. I
wonder if I am getting some
separation in floor
support that need to be
addressed, or whether these
types of squeaks are just
something that can develop in
time. Robert had told me earlier
about adding glass tabbing to
the bulkhead areas
and the hull and the mast well
box. Additionally, glassing was
done at the
galley bulkhead, and a small
bulkhead was glassed into the
keel bilge
approximately adjacent to the
wet locker and chart table. The areas he mentions are the
areas I am getting the floor
squeaking. I am
not in a place where this type
of work can be done, nor are
materials
available. I just need to know
how critical this is, thus how
soon I must
address it. Thanks for any help you can
provide. Hope all is well with
your boat and
cruising activities. Best wishes
for the holiday season. Bill Gloege
Gaia
Banana Bay marina
Golfito, Costa Rica
</div>