Fortin024
Member
Hey folks,
I’ve replaced my water pump due to the old one drawing too much power. I’ve come to the conclusion that these water pumps don’t like pushing water in the 3/8 poly and makes them work harder.
The new jabsco Parmax hd4 max current draw is 10 amps and I’m at 10 amps each time I use it.
So I’m redrawing my plumbing setup right now and would like to know if any of you have tips and tricks to get the two hose fed from the galley under the settee to the head up forward.
Do I have to cut access under the settee or will I be able to tie something to the end of the old poly hose and pull it through? Our boats tend to have stuff zapstrapped to the haul and then everything was built over it.
Any suggestions is welcome,
Cheers,
Mike
I’ve replaced my water pump due to the old one drawing too much power. I’ve come to the conclusion that these water pumps don’t like pushing water in the 3/8 poly and makes them work harder.
The new jabsco Parmax hd4 max current draw is 10 amps and I’m at 10 amps each time I use it.
So I’m redrawing my plumbing setup right now and would like to know if any of you have tips and tricks to get the two hose fed from the galley under the settee to the head up forward.
Do I have to cut access under the settee or will I be able to tie something to the end of the old poly hose and pull it through? Our boats tend to have stuff zapstrapped to the haul and then everything was built over it.
Any suggestions is welcome,
Cheers,
Mike