<div>For those of you who have installed below deck autopilots, I am
seeking some info on the selection and attachment of the tiller
arm that is connected to the actuator and rudder stock. I would
like the specs used on an M383 application if possible. After
much deliberation, I have settled on the AutoHelm ST5000+
Sailpilot as middleground between the 4000 and 6000 (at least
pricewise). It seems strong enough and still affordable and I
hope I made the right choice. The tller arms made by Edson seem
to be the obvious choice athough adding another $300 to the
total price was not a welcomed discovery.I studied the photos posted to our site a few months ago
(http://www.navstore.com/autonav/) that depicted a below decks
installation and determined that an Edson 10" arm was used but I
couldn't figure out how it was attached to the stock.If anybody has pictures of their installation it would be
appreciated. Send by mail or email.Alan C. Tigner
18 N. Chestnut Court
Hawthorn Woods, IL 60047
847-550-0381
</div>
seeking some info on the selection and attachment of the tiller
arm that is connected to the actuator and rudder stock. I would
like the specs used on an M383 application if possible. After
much deliberation, I have settled on the AutoHelm ST5000+
Sailpilot as middleground between the 4000 and 6000 (at least
pricewise). It seems strong enough and still affordable and I
hope I made the right choice. The tller arms made by Edson seem
to be the obvious choice athough adding another $300 to the
total price was not a welcomed discovery.I studied the photos posted to our site a few months ago
(http://www.navstore.com/autonav/) that depicted a below decks
installation and determined that an Edson 10" arm was used but I
couldn't figure out how it was attached to the stock.If anybody has pictures of their installation it would be
appreciated. Send by mail or email.Alan C. Tigner
18 N. Chestnut Court
Hawthorn Woods, IL 60047
847-550-0381
</div>