rene_m
Rene Marin
So, when i got my boat there were no zinc's anywhere and the prop paid the price for it.
I have been doing research but not with any luck. The collar type does not leave enough room between the cutlass bearing and the prop for good flow and the prop shaft is close to the rudder.
I made this set up but it was a stop gap. I had to reshape the tail end to get it to fit.
The guys at the boat yard were impressed when i came back with a milled zinc and installed it. but its getting eaten up quick.
Any suggestions on zinc's or how to slow the process?
I have been doing research but not with any luck. The collar type does not leave enough room between the cutlass bearing and the prop for good flow and the prop shaft is close to the rudder.
I made this set up but it was a stop gap. I had to reshape the tail end to get it to fit.
The guys at the boat yard were impressed when i came back with a milled zinc and installed it. but its getting eaten up quick.
Any suggestions on zinc's or how to slow the process?