right. I will drop the rudder before I move the engine.
Hey, Jim, speaking of bearings, I need to replace mine. Years ago a creative yard figured out how to replace it somehow, without dropping the...
Those with Max-props AND a Perkins 4-108, what size Max-Prop do you run? And do you have the new kind that one can adjust without opening it up...
I have a line control telescoping pole stored on the front of the mast. Probably something like 16.5' collapsed, 25' extended. (In collapsed...
let us all know how it turns out. we could all learn from you now.
John, is the area into which the screws go solid glass (which I believe to be the case) or cored? Thanks.
All the shunts and amp meters are both complicated and, from what I have read, of questionable accuracy, especially over time. I have a Balmar...
383s and 384s have taller masts than 382s. Someone with a 384 can probably provide dimensions. 382 masts were built by Kenyon, which is now part...
Here is the problem with the PVC. Epoxy and polyester resin will not stick to it. Morgan put lots of mud of some sort around the pipes, but mine...
I am refurbishing my Edson steering system (again). Two questions: what are the best engine control cables? Do I get Edson's or is there...
I think flexible solar panels are typically less productive or more expensive than hard. Check out E Marine. They were good to deal with,...
Whatever you offer, make it contingent on a competent survey with the boat hauled. Don't let the seller or a broker provide a surveyor. Ask...
oops. Left out the M. I do have an M before the 79. But why? MRY surely stands for Morgan Yachts.
my Morgan 382 number never says 38 0r 382. It is MRY2216379I. The 22 stands for 382 (don't know why), the 163 is hull number 163 of the 382...
Part of the corrosion at the base is my fault. Years ago I altered the mast step to make sure water did not collect inside the mast base and the...
I rarely pull my mast. 20 years ago, I found it was corroded to the aluminum mast step and we ripped the bolts holding down the step out of the...
Keefer: Who rebuilt the injector pump and which model pump is it? If you decide to part the engine out I might be interested in purchasing the...
on sound proofing, I have used something that has "mass loaded vinyl"sandwiched between two layers of foam. Soundown makes it, I believe....
John Harrison says he replaced the miserable CAV secondary filter on his Perkins, which I have always wanted to do, but I didn't think there was a...
I don't think I have pvc pipe through the blob to help the drainage. So things have dropped 1/2" even with the blob. That must have been part...
Separate names with a comma.
